Posts

Enter password on Home Screen if one has been set.

Image
  Press the on/off button on the side of theprojector and wait for it to power on. Press power button.Once on the home screen, go back to Menu and select Settings > Projector Setup >Output Settings (or similar)Choose desired resolution such as 1080p or 720p (these settings will vary depending on individual projectors) Make sure "Display" is set to On and check cables if necessary.Turn on the projector. Adjust brightness/contrast, if necessary using the button or remote.At this point we can also turn on the built-in speakers and audio system. NOTE: you may want to close any doors/windows leading to the room where you are sitting to prevent noise from reaching the projector screen.Now that your projectors ready, make sure you follow these instructions carefully and do not skip steps This is what the steps are supposed to look like when done correctlyA very useful feature is Remote Control which allows you to change settings via free remote application for Android or iO

To turn on promethean projector without remote:

Image
  1. Turn the projector off2. Press and hold the Menu button while you power it on with your remote control.   Image source: https://www.asus.com/ 3. While still holding down the button, press any button on your remote control to enter Setup mode. Then press and hold either Enter or Exit to enter System setup mode, depending on which screen appears first (see below).   Image source: https://www.homedepot.com/ 4. Press the left arrow button on your remote control until the On option is highlighted, then press Enter. 5. Press the right arrow button until Standby Delay is highlighted, then press Enter.   Image source: https://www.dell.com/ 6. Press the up and down arrow buttons to set Standby Delay to 2 or 3 minutes, then press Enter. Press Exit to exit System setup mode.   Image source: https://www.optoma.com/ 7. To exit Settings mode, press Menu and then Exit. ***How to reset promethean projector without remote***    Image source: https://www.croma.com/ 1) unplug power cord